Start Here

How do you Change, Replace, or Install Broken 1998-2002 Mercury Grand Marquis Rear Door Panel (Interior) Replacement

Fits years: 1998, 1999, 2000, 2001, 2002

All Mercury Grand Marquis for sale Tools required:

  • Phillips screwdriver

  • Flathead screwdriver


Step 1: Open the vehicle's REAR door.

Step 2: Pry and life the power window control panel. Loosen and remove the Phillips screws (2) on the UNDERSIDE of the panel, and disconnect the wiring harness (1).

Step 3: Pry and remove the interior door handle's bezel.

Step 4: Pry and remove the screw covers (2) on the interior door pull. Loosen and remove the Phillips screw (1).

Step 5: Loosen and remove the Phillips screw (1) exposed by removing the power window control panel.

Step 6: Loosen and remove the Phillips screw (1) on the BOTTOM edge of the interior door panel.

Step 7: You can now LIFT and remove the interior door panel from the door frame.

Step 8: To reattach the interior door panel, slide the panel OVER the locking lever and onto the door frame.


NOTE: Be sure that you feed the wiring harness through the opening in the door.

Step 9: Tighten the Phillips screws (4).

The shorter screws are for the door pull!

Step 10: Reattach the screw covers (2), and the interior door handle's bezel.

Step 11: Reconnect the wiring harness (1), tighten the Phillips screws (2), and snap the power window control panel back into place.
These Part Change / Installation Instructions Apply to:

98 1998, 99 1999, 00 2000, 01 2001, 02 2002 Mercury Grand Marquis Replacement Instructions

Average Rating: 4.8 of 5 stars
46 Review(s)

Let your friends know this guide can help them!



© 2015 GO-PARTS. All Rights Reserved.