2000-2006 Nissan Sentra AC Heater Fan Speed Resistor Replacement

Tools required:

  • Phillips screwdriver (medium and small)


NOTE: For this repair, the components are located beneath the dashboard on the PASSENGER'S side of the vehicle.

Step 1: Open the vehicle's glove compartment. Slide the compartment to the LEFT and remove it from the dashboard.

Step 2: Loosen and remove the Phillips screws (2) that secure the underside panel in place.


NOTE: This panel will pull out from UNDERNEATH the glove compartment, exposing the blower motor assembly.

Step 3: Disconnect the wiring harness (1) attached to the fan speed resistor.

Step 4: Loosen and remove the Phillips screws (2) that secure the resistor to the blower motor assembly.


You may need to use 2 different screwdrivers, given the location of these screws.

Step 5: You can now remove the resistor from the vehicle.

Step 6: Insert the fan speed resistor into the blower motor assembly, and secure it by tightening the Phillips screws (2).

Step 7: Connect the fan speed resistor's wiring harness (1).

Step 8: Reattach the trim panel, and secure it by tightening the Phillips screws (2).

Step 9: Reattach the glove compartment by sliding it into position.

Contact


Go-Parts.com ©

Told-Free: 1-877-321-PART

International: 1-916-993-3700

Our mission

We know how important it is for you to be back on the road, so we strive to make your buying experience as easy and fast as possible.

NEWSLETTER SIGN UP

© 2014 GO-PART.COM. All Rights Reserved.