Español: (916) 374-7279
Start Here

How do you Change, Replace, or Install Broken 2000-2004 Subaru Outback Rear Door Panel Replacement

Fits years: 2000, 2001, 2002, 2003, 2004

All Subaru Outback for sale Tools required:

  • Phillips screwdriver

  • Flathead screwdriver


Step 1: Open the vehicle's REAR door.

Step 2: Pry and remove the power window switch from the door frame. Disconnect the wiring harness (1).

Step 3: Pry and remove the interior door handle's bezel.

Step 4: Pry and remove the screw cover (1) located on the interior door pull.

Step 5: Loosen and remove the Phillips screw (1) exposed by removing the screw cover.

Step 6: Pry and remove the Phillips screw (1) exposed by removing the power window switch.

Step 7: You can now LIFT and remove the interior door panel.


You will hear the retaining clips securing the panel to the door frame "pop" as they disengage.

Step 8: To reattach the panel, slide it over the "lip" near the window, and FIRMLY strike near each retaining clip. They will "snap" into place.

Step 9: Reattach the interior door handle's bezel.

Step 10: Tighten the Phillips screws (2).

Step 11: Reattach the screw cover (1).

Step 12: Connect the window switch's wiring harness (1) and "snap" the switch back into place on the door panel.
These Part Change / Installation Instructions Apply to:

00 2000, 01 2001, 02 2002, 03 2003, 04 2004 Subaru Outback Replacement Instructions

Average Rating: 5 of 5 stars
1 Review(s)

Let your friends know this guide can help them!



Contact


Go-Parts.com ©

Toll-Free: 1-877-321-PART

International: 1-916-273-4760

Our mission

We know how important it is for you to be back on the road, so we strive to make your buying experience as easy and fast as possible.

© 2015 GO-PARTS. All Rights Reserved.