Start Here

How do you Change, Replace, or Install Broken 2001-2005 Chrysler PT Cruiser Turn Signal, Wiper Switch Replacement

Fits years: 2001, 2002, 2003, 2004, 2005

All Chrysler PT Cruiser Turn Signal Lights for sale Tools required:

  • T10 Torx Driver

  • 10mm wrench

  • Phillips screwdriver

  • Flathead screwdriver


Step 1: Disconnect the vehicle's negative battery cable using the 10mm wrench.

Step 2: Pull and lower the swing panel beneath the steering column.

Step 3: Loosen and remove the Phillips screws (2) on the underside of the steering column.

Step 4: Pry and remove the UPPER and LOWER trim panels that surround the steering column.

Step 5: Loosen and remove the Phillips screws (2) on the top of the switch assembly.

Step 6: Disconnect the wiring harnesses (2 " 1 on each side) from the backside of the switch assembly.

Step 7: You can now remove the switch assembly from the steering column.

Step 8: Loosen and remove the T10 Torx screws (2) that secure the turn signal/wiper switch to the switch-plate. Remove the switch.

Step 9: Mount the new turn signal/wiper switch to the switch-plate assembly by tightening the T10 Torx screws (2).

Step 10: Connect the wiring harnesses (2) to the back of the switch-plate assembly.

Step 11: Mount the switch-plate to the steering column by tightening the Phillips screws (2).

Step 12: Reattach the UPPER and LOWER trim panels that surround the steering column. Tighten the Phillips screws (2) to secure the panels.


NOTE: Be sure not to catch the protective foam between the panels!

Step 13: Close the swing panel underneath the dashboard.

Step 14: Reconnect the negative battery cable with the 10mm wrench.
These Part Change / Installation Instructions Apply to:

01 2001, 02 2002, 03 2003, 04 2004, 05 2005 Chrysler PT Cruiser Turn Signal Lights Replacement Instructions

Average Rating: 4.9 of 5 stars
28 Review(s)

Let your friends know this guide can help them!



© 2015 GO-PARTS. All Rights Reserved.