Start Here

How do you Change, Replace, or Install Broken 2004-2007 Chrysler Town and Country Front Door Panel (Interior) Replacement

Fits years: 2004, 2005, 2006, 2007

All Chrysler Town & Country for sale Tools required:

  • Phillips screwdriver

  • 12mm wrench

  • Door Panel Clip Tool (or putty knife)


Step 1: Using the 12mm wrench, disconnect the vehicle's negative battery cable.

Step 2: Pry and lift the power window control plate. Disconnect the wiring harness (1).

Step 3: Loosen and remove the Phillips screw (1) inside the interior door handle.

Step 4: Loosen and remove the Phillips screw (1) inside the interior door pull.

Step 5: Using the door panel clip tool (or putty knife), pry and remove the door panel from the door frame.


A series of retaining clips secures the door panel to the frame. You will hear them "pop" as they disengage.

Step 6: LIFT the door panel to remove it. Disengage the retaining clip (1) that secures the locking rod to the back of the panel. Also, disconnect the wiring harness (1).

Step 7: To reattach the panel, insert the locking rod and secure it by re-engaging the retaining clip (1). Connect the wiring harness (1), as well. You can now slide the door panel over the "lip" by the window.

Step 8: With a firm strike near the retaining pins, you can "snap" them back into place.

Step 9: Tighten the Phillips screws (2).

Step 10: Connect the wiring harness to the power window control plate (1), and snap it back into place.
These Part Change / Installation Instructions Apply to:

04 2004, 05 2005, 06 2006, 07 2007 Chrysler Town & Country Replacement Instructions

Average Rating: 4.9 of 5 stars
32 Review(s)

Let your friends know this guide can help them!



© 2015 GO-PARTS. All Rights Reserved.