Start Here

How do you Change, Replace, or Install Broken 2008-2010 Chrysler Town & Country, Dodge Caravan Tail Light Replacement

Fits years: 2008, 2009, 2010

All Chrysler Town & Country Tail Lights for sale Tools required:

  • T30 Torx Driver


Step 1: Open the vehicle's rear hatch.

Step 2: Loosen and remove the T30 Torx screws (2) that secure the tail light to the vehicle.

Step 3: You can now pull STRAIGHT OUT from the vehicle to remove the tail light assembly.


There are two mounting studs that prevent you from being able to pull sideways on the light!

Step 4: Disconnect the wiring harnesses (2) attached to the back of the tail light.

NOTE: If you ordered your replacement tail light from Go-Parts, it likely includes new sockets and bulbs, as most of our models do. This saves you an installation step! However, if your particular model does not, simply twist and remove the sockets from the old assembly and attach them to the new one.

Step 5: Connect the wiring harnesses (2) to the back of the NEW tail light.

Step 6: Mount the tail light by sliding it into position and tightening the T30 Torx screws (2).
These Part Change / Installation Instructions Apply to:

08 2008, 09 2009, 10 2010 Chrysler Town & Country Tail Lights Replacement Instructions

Average Rating: 4.9 of 5 stars
32 Review(s)

Let your friends know this guide can help them!



Contact


Go-Parts.com ©

Toll-Free: 1-877-321-PART

International: 1-916-993-3700

Our mission

We know how important it is for you to be back on the road, so we strive to make your buying experience as easy and fast as possible.

© 2015 GO-PARTS. All Rights Reserved.