Start Here

How do you Change, Replace, or Install Broken Ford Explorer, F-150 V8 2.0L, 2.4L, 4.6L, 5.0L Ignition Coil Replacement

Fits years: 0

All Ford Explorer for sale Tools required:

  • 7mm socket/ratchet with extension


Step 1: Open the vehicle's hood.

NOTE: If you are performing this project on a V8, there will be (2) ignition coils. However, 4-cylinder models only require (1) ignition coil. We will proceed with this installation guide as if there was (1), but you may have to perform this process twice (once for each coil).

Step 2: Disengage the air box intake hose's clamp (1) and pull it form the casing, exposing the ignition coils.

NOTE: During this installation, we'll be removing the plug cables from the ignition coil. We recommend numbering them in a manner in which you can easily place them back onto the SAME position they were in on the old ignition coil.

Step 3: Loosen and remove the 7mm mounting bolts (4) that hold the ignition coil to the vehicle.

Step 4: Remove the plug cables (4) from the ignition coil.

Step 5: You can now pull the ignition coil from the vehicle.

Step 6: Mount the new ignition coil to the vehicle by tightening the 7mm bolts (4). Be sure to attach the wiring harness (which relies on one of the mounting bolts).

Step 7: Connect the plug cables (4) to the ignition coil.


NOTE: Remember, use the numbering system that we established before Step 3!

Step 8: Reattach the air intake hose to the air box by re-engaging the retaining clamp (1).
These Part Change / Installation Instructions Apply to:

0 Ford Explorer Replacement Instructions

Average Rating: 4.9 of 5 stars
15 Review(s)

Let your friends know this guide can help them!



Contact


Go-Parts.com ©

Toll-Free: 1-877-321-PART

International: 1-916-993-3700

Our mission

We know how important it is for you to be back on the road, so we strive to make your buying experience as easy and fast as possible.

© 2015 GO-PARTS. All Rights Reserved.