Step 2: Loosen and remove the 11mm retaining bolt (1) that holds the turn signal assembly in place.
This bolt is located just behind where the headlight and turn signal assemblies meet.
Step 3: You can now pull the turn signal assembly from the vehicle.
You may need to give it a tub, as the retaining pins are still engaged on the back of the assembly.
Step 4: Disconnect the wiring harness from the back of the turn signal assembly.
NOTE: Some models do not use wiring plugs for the turn signals. If this is the case for your particular model, simply turn the socket/bulb counter-clockwise to remove them from the existing assembly.
Step 5: Connect the wiring harness to the new turn signal assembly.
Step 6: Mount the turn signal assembly by tightening the 11mm retaining bolt (1).
Use the guiding pins on the back of the assembly to ensure proper placement and installation.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
97 1997, 96 1996, 95 1995, 94 1994, 93 1993 Ford Ranger Corner Light Replacement Instructions