Step 1: Loosen and remove the Phillips screw that holds the turn signal assembly in place.
This screw is accessible from the exterior of the vehicle.
Step 2: You can now pull the turn signal assembly from the vehicle.
Step 3: Disconnect the turn signal's wiring harness.
Step 4: Connect the wiring harness to the new turn signal assembly.
Step 5: Mount the turn signal assembly by tightening the Phillips retaining screw.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: