Step 1: Locate the T2 Torx screw that is between the headlight assembly and the blinker and remove it.
Step 2: Remove the two T2 screws that hold the marker light in place.
Step 3: Remove the marker light, but leaving it connected, move it to the side.
Step 4: You can now pull the headlight assembly from the vehicle.
Step 5: Disconnect the wiring harness on the back of the assembly.
NOTE: If you purchased your replacement headlight from Go-Parts, it likely includes the bulbs (as most of our models do). This saves you time, and allows you to move on to the installation of the new assembly.
Step 6: Connect the wiring harness to the new headlight assembly and move it into position.
Step 7: Secure the marker light by tightening the T2 mounting screws.
Step 8: Tighten the T2 screw that rests between the headlight assembly and the blinker.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
98 1998, 97 1997, 96 1996, 95 1995, 94 1994, 93 1993 Jeep Grand Cherokee Headlight Replacement Instructions