Step 2: Loosen and remove the three 10mm bolts that secure the tail light assembly to the vehicle.
Step 3: You can now pull the tail light assembly from the vehicle.
Step 4: Disconnect the wiring harnesses on the back of the tail light assembly.
NOTE: If you ordered your replacement tail light from Go-Parts, it likely includes new bulbs, as most of our models do. This saves you an installation step! However, in case your assembly does not have new bulbs, simply turn the sockets to pull them from the old assembly and insert them into the new one.
Step 5: Connect the wiring harnesses to the new tail light assembly.
Step 6: Insert the tail light assembly into place.
Use the guiding pin on the back of the assembly to ensure proper placement.
Step 7: Secure the tail light assembly by tightening the three 10mm retaining bolts.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
98 1998, 97 1997, 96 1996, 95 1995, 94 1994, 93 1993 Jeep Grand Cherokee Tail Light Replacement Instructions