Step 1: Through the opening in the undercarriage protection panel, locate the Phillips retaining screw and remove it.
Step 2: You can now pull the light through the front of the vehicle.
Step 3: Disconnect the wiring harness.
Step 4: Connect the wiring harness to the new turn signal light.
Step 5: By lining up the new assembly with the guiding tab, move it into place.
Step 6: Tighten the Phillips retaining screw.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
95 1995, 94 1994 Honda Accord Front Signal Light Replacement Instructions