Step 1: By covering the putty knife or clip tool with a rag to protect the paint, remove the gasket that surrounds the headlight assembly.
Step 2: Using a Phillips screwdriver, remove the retaining screws that hold the parking light in place.
Step 3: Pull the parking light from the vehicle and disconnect the wiring harness.
Step 4: Using the 10mm socket /ratchet with extension, remove the three 10mm retaining bolts that secure the headlight assembly into place.
Step 5: Locate the retaining pin that is near the upper rear of the assembly and disengage it to remove the assembly from the vehicle.
Step 6: Gently remove the headlight assembly.
NOTE: If you purchased your replacement headlight from Go-Parts, the bulbs are likely included with the replacement. This can save you time, as you can move directly on to Step 7!
Step 7: Connect the wiring harness to the new headlight assembly.
Step 8: Engage the retaining clip near the back of the assembly.
Step 9: Tighten the 10mm retaining bolts to secure the headlight assembly.
Step 10: Replace the gasket pins to secure the rubber protective gasket.
Step 11: Reconnect your parking light and secure it into place.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: