Step 1: Locate the protective panel that is just below the glove compartment on the passenger's side of the vehicle. By gently pulling on it, you can disengage the clips.
Step 2: Remove the two retaining Phillips screws on each side of the underside of the glove compartment. You can now remove the panel.
Step 3: Using the Phillips screwdriver (you'll need a small one), remove the two Phillips retaining screws that hold the wiring harness panel in place. You can now slide this bundle out of your way.
Step 4: With the blower motor now exposed, disconnect its wiring harness and remove the three 8mm retaining bolts. You can now pull the blower motor from the vehicle.
Step 5: Mount the new blower motor to the vehicle by tightening the three 8mm retaining bolts.
NOTE: Be sure that you have it lined up correctly and move the wiring harness out of the way!
Step 6: Reconnect the wiring harness to the blower motor.
Step 7: Secure the wiring harness panel by tightening the 2 Phillips screws.
Step 8: Reattach the protective panel by tightening the Phillips screws and snapping the tabs back into place.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
99 1999, 98 1998, 97 1997, 96 1996, 95 1995 Toyota Avalon AC Heater Blower Motor Replacement Instructions