Step 1: From beneath the vehicle, disconnect the turn signal's wiring harness.
Step 2: Loosen and remove the 2 Phillips retaining screws that hold the turn signal assembly in place.
These screws are located on each side of the assembly.
Step 3: You can now pull the turn signal assembly from the vehicle.
Step 4: Using the flathead screwdriver, remove the small retaining clips that likely stayed with the vehicle when removing the assembly.
These clips are often included with our new assemblies, so you won't need the old ones!
Step 5: Move the new turn signal assembly into position. You will feel the retaining clips "snap" into place.
Step 6: Secure the assembly by tightening the 2 Phillips retaining screws.
Step 7: Connect the turn signal assembly's wiring harness.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
02 2002, 01 2001, 00 2000, 99 1999 Toyota 4Runner Front Signal Light Replacement Instructions