Step 2: Lift and remove the plastic panel that covers the headlight/turn signal mounting area.
Step 3: Loosen and remove the E8/7mm bolt that holds the side marker light assembly in place.
This bolt is located just behind the point where the side marker and headlight assemblies meet.
Step 4: You can now pull the side marker light from the vehicle.
Step 5: Disconnect the side marker light's wiring harness.
Step 6: Connect the wiring harness to the new side marker light.
Step 7: Mount the side marker light by tightening the E8/7mm bolt.
Use the guiding tabs to ensure proper placement when re-installing the component.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: