Step 1: Remove the protective gasket that separates the headlight assembly and the radiator area.
Disengage the mounting pins to pull it back.
Step 2: Locate and remove the T10 Torx screw that mounts the parking light into place.
This screw is located between the headlight and the parking light when facing the vehicle.
Step 3: You can now pull the parking light from the vehicle.
Step 4: Disconnect the wiring harnesses from the back of the parking light assembly.
You may need to twist and remove the bulbs from the assembly if the new assembly does not have bulbs included.
Step 5: Connect the wiring harnesses to the back of the new parking light assembly.
Step 6: Mount the new parking light assembly by tightening the T10 Torx retaining screw.
Step 7: Reattach the protective gasket using the mounting clips.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: