Step 2: Loosen and remove the hand-screw that's above the turn signal assembly.
You may need pliers for this step.
Step 3: You can now pull the turn signal assembly from the vehicle.
NOTE: There is a retaining clip that attaches the turn signal to the headlight. When removing the turn signal, it can sometimes detach from the turn signal and stay with the headlight. Remove it, as your new assembly likely has the clip already attached.
Step 4: Twist the bulb and remove it from the existing turn signal.
Step 5: Screw the bulb/socket into the new turn signal casing.
Step 6: Install the new turn signal assembly.
Use the two tabs as your guides to ensure proper installation. Slide it into place, and be sure that the mounting clip engages to the headlight assembly.
Step 7: Tighten the hand-screw that secures the turn signal to the vehicle.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: