Quick Parts Search
Quick Parts Search
Need Some Help?

Go-parts Reviews - SiteJabber

How do you Change, Replace, or Install Broken 1998-1998 Ford Mustang V6 Cooling Fan Replacement

Tools required:
  • 8mm socket/ratchet

  • 7mm socket/ratchet

Step 1: Open the vehicle's hood.

Step 2: Loosen and remove the 7mm retaining bolt that holds the coolant tank in place. Push it back to give you some extra room to work. Detach the hose running from it, as well.

Step 3: Disconnect the wiring harness attached to the radiator's cooling fan. Pull the wiring from the radiator fans, detaching the retaining clips that hold the wiring bundle in place.

Step 4: Loosen and remove the two 8mm bolts that hold the cooling fan assembly in place.

Step 5: Lift and remove the cooling fan assembly.

This may take some maneuvering as the space is limited! But, by pushing the assembly back from the radiator and lowering the left side of the assembly, you should be able to pull it from the vehicle relatively easily.

Step 6: Slide the new cooling fan into position, and secure it by tightening the two 8mm retaining bolts.

Use the guiding tab attached to the radiator (near the bottom of the fan assembly) to ensure proper placement and installation.

Step 7: Reattaching the wiring bundle to the radiator fans using the retaining clips and connect the fan's wiring harness.

Step 8: Tighten the 7mm bolt that holds the coolant tank in place.

Be sure to reattach the hose that runs from the coolant tank!

Please Note

While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.

And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.

If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out:

98-98 Ford Mustang Radiator Cooling Fan Assembly
W/3.8L V6 Engine

These Part Change / Installation Instructions Apply to
98 1998 Ford Mustang V6 Cooling Fan Replacement Instructions

2000 Ford Mustang Serpentine Belt Replacement

1999-2004 Ford Mustang 3.8L Engine Belt Idler Pulley Replacement

1999-2004 Ford Mustang Front Door Panel (Interior) Replacement

1999-2004 Ford Mustang Side Mirror Replacement

1999-2004 Ford Mustang Side Mirror Replacement

1999-2004 Ford Mustang Tail Light Replacement

1994-2004 Ford Mustang 3.8L V6 Air Filter Replacement

1994-2004 Ford Mustang AC Heater Blower Motor Replacement

1994-2004 Ford Mustang AC Heater Fan Speed Control Resistor Replacement

Your cart is completely and totally empty!

USERNAME (Your E-Mail)

Sign UpForgot Password

Enter email address here:

Official PayPal Seal