Step 1: Disconnect the electrical lead that is exposed near the headlight assembly after opening the vehicle's hood.
Step 2: Disengage the three retaining tabs that hold the headlight assembly in place.
Step 3: You can now pull the headlight assembly from the vehicle.
Step 4: Disconnect the wiring harnesses that are attached to the back of the assembly.
NOTE: If you ordered your replacement headlight assembly from Go-Parts, it likely has new bulbs included (as most of our models do)! If so, you can save time by moving right to the installation process. However, if it doesn't, you can easily twist the bulb sockets and remove them from the back of the assembly.
Step 5: Connect the wiring harnesses to the back of the new headlight assembly.
Step 6: Insert the new headlight into the chassis and connect the wiring lead that we disconnected in step one.
Use the alignment tabs as your guide to ensure proper installation.
Step 7: Secure the headlight's position by re-engaging the retaining clips.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: