Step 2: Remove the protective panel that covers the radiator area.
Turn the clips (one at each end) counter-clockwise. Then, remove the clips and the panel.
Step 3: Loosen and remove the 11mm bolt that mounts the side marker assembly to the vehicle.
You will need an extension to reach this bolt!
Step 4: Loosen and remove the Phillips screw that is on the exterior of the marker light assembly.
Step 5: You can now pull the side marker light from the vehicle.
Step 6: Disconnect the wiring harnesses from the back of the marker light.
Step 7: Connect the wiring harness to the new marker light, and clip the harness to the assembly using the small retaining clip on the back.
Step 8: Mount the new side marker assembly by tightening the Phillips screw and the 11mm retaining bolts.
Step 9: Reattach the protective panel by re-engaging the two retaining clips (one at each end).
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
02 2002, 01 2001, 00 2000, 99 1999, 98 1998 Mercury Grand Marquis Corner Light Replacement Instructions