How do you Change, Replace, or Install 1998-2003 Dodge Durango Rear Door Panel (Interior) Replacement
Click here for all of our other replacement guides
Step 1: Pry and remove the trim panel that runs TOP to BOTTOM on the rear of the door's window.
Step 2: Loosen and remove the Phillips screw (1) exposed by removing this trim panel.
Step 3: Loosen and remove the Phillips screws (4) that secure the door panel to the vehicle.
One is located inside the interior door handle, one is inside the interior door pull, and two are located along the bottom edge of the panel.
Step 4: You can now lift and remove the interior door panel.
Step 5: Disconnect the wiring harness (1) from the back of the interior door panel.
Step 6: Disengage the locking rod (1) from the back of the interior door panel by unlocking the retaining clip.
Step 7: To reattach the door panel, reconnect the wiring harness (1) and re-engage the locking rod (1).
Step 8: Slide the door panel over the lip and onto the door frame.
Step 9: Tighten the Phillips screws (5).
Step 10: Reattach the window's trim panel.
These Part Change / Installation Instructions Apply to
03 2003, 02 2002, 01 2001, 00 2000, 99 1999, 98 1998 Dodge Durango Rear Door Panel (Interior) Replacement Instructions
- POPULAR GUIDES: DODGE DURANGO -
Dodge Durango, Dakota Front Axle CV Joint Replacement
2004-2009 Dodge Durango AC Heater Blower Motor Replacement
2004-2009 Dodge Durango Engine Air Filter Replacement
2004-2009 Dodge Durango Side Mirror Replacement
2004-2009 Dodge Durango Tail Light Replacement
2004-2006 Dodge Durango Headlight Replacement
1998-2003 Dodge Durango Radiator Grille Replacement
1998-2003 Dodge Durango Tail Light Replacement
1998-2003 Dodge Durango, Dakota 3.9L, 5.2L, 5.9L Ignition Coil Replacement
Shipping & Returns
Toll Free No: 1-877-321-PART
Your cart is completely and totally empty!
Enter email address here: