Step 2: Disengage the locking tabs and pull the headlight from the vehicle.
NOTE: Be sure to avoid dropping the locking tabs down into the engine compartment, otherwise you'll be spending time fishing them out!
Step 3: Disconnect the wiring harness and completely remove the old headlight assembly.
NOTE: If you ordered your new headlight assembly from Go-Parts, it may have all of the bulbs included with the assembly. If so, you can save steps and simply move onto installation!
Step 4: Connect the wiring harness to the new headlight assembly and move it into place.
Be careful not to pinch the wiring while you are installing the headlight. Use the tabs on the bottom of the assembly to ensure proper installation.
Step 5: Secure the new headlight assembly by locking the retaining tabs into place.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
04 2004, 03 2003, 02 2002, 01 2001, 00 2000, 99 1999, 98 1998 Chevrolet S10 Headlight Replacement Instructions