Step 1: Remove the plastic panel that covers the radiator area of your engine.
Three clips hold this panel in place. By disengaging these clips, the panel will pull right out.
Step 2: Remove the two retaining clips using a lever that are mounted to each side of the headlight assembly.
Step 3: You can now remove the headlight assembly by pulling the light through the front of the vehicle.
Step 4: Disconnect the wiring harnesses attached to the back of the headlight assembly.
Step 5: Attach the wiring harnesses to the back of your new headlight assembly.
NOTE: To be sure that your headlight is aligned properly, you can set your "adjusting posts" to match the same length as the posts on your old headlight.
Step 6: Push your headlight assembly into place.
Step 7: Secure the assembly by reattaching the retaining clips.
Step 8: Reattach the plastic cover.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
11 2011, 10 2010, 09 2009, 08 2008, 07 2007, 06 2006, 05 2005, 04 2004, 03 2003, 02 2002, 01 2001, 00 2000, 99 1999, 98 1998 Ford Crown Victoria Headlight Replacement Instructions