Step 2: Loosen and remove the Phillips retaining screw that holds the marker light in place.
This screw is located above where the side marker light meets the headlight.
Step 3: With a firm tug, you can now pull the side marker assembly from the vehicle.
Step 4: Disconnect the wiring harness from the back of the side marker light.
Step 5: Connect the wiring harness to the new marker light assembly.
Step 6: Snap the side marker light into place, and secure it by tightening the Phillips retaining screw.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: