Step 1: Loosen and remove the 2 Phillips screws beneath the turn signal/marker light.
These screws are accessible from the front of the vehicle. Be careful not to drop them!
Step 2: You can now pull the assembly from the front of the vehicle.
Step 3: Disconnect the 2 wiring harnesses from the back of the side marker/turn signal assembly.
Step 4: Connect the wiring harnesses to the new marker light assembly, and mount it into place by tightening the 2 Phillips mounting screws.
Use the retaining pins to ensure proper alignment during installation.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: