Step 1: Using the flathead screwdriver, pull up on the center of the retaining clips (located on top of the assembly) and disconnect them.
Step 2: Lift the plastic cover.
Step 3: Locate the retaining tabs and disengage them using your pliers.
You'll want to pull "back" and then "up and out".
Step 4: Pull the headlight assembly from the vehicle.
Step 5: Disconnect the wiring harness from the old headlight assembly.
NOTE: If you ordered your replacement headlight from Go-Parts, it may come with all of the bulbs. This will help you save steps, as you won't have to unscrew the sockets from the old assembly.
Step 6: Using a screwdriver, adjust the new headlight assembly.
Match the screw stems to meet the length of the stems on the old assembly. This will keep your beams adjusted at the proper height.
Step 7: Connect the wiring harness to the new headlight assembly and insert it into position.
You'll want to line up all of the pegs to ensure proper placement. The adjustor will fit perfectly into position, as well. Insert the interior side of the light (when facing it from the front of the vehicle) first.
Step 8: Reattach the retaining tabs to hold the new assembly firmly in place.
Step 9: Replace the plastic cover.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: