Step 1: Using the 10mm socket, remove the two 10mm bolts that secure the junction box in place.
The junction box is located just below the blower motor.
Step 2: Remove the rubber hose from the blower motor and remove the lower bolt that holds the blower motor in place. Disconnect the wiring harness from the blower motor.
There will be 3 8mm bolts.
Step 3: You can now pull the blower motor from the vehicle.
Step 4: Remove the small rubber tube (and its securing tie) from the old blower motor.
Step 5: Put the gasket around the new blower motor, attach the small rubber hose, and move the component into position.
Step 6: Connect the wiring harness to the new blower motor.
Step 7: Secure the blower motor's position by tightening the 3 8mm retaining bolts.
Step 8: Reattach the small rubber boot.
Step 9: Secure the junction box by tightening the 10mm retaining bolts.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: