Step 2: Locate the three 10mm retaining bolts and remove them.
These bolts are located on the upper-outside region of the assembly (beneath the hood), the upper-interior region, and lower-interior region.
Step 3: You can now remove the headlight assembly from the vehicle.
Step 4: Disconnect the wiring harnesses from the back of the headlight assembly.
NOTE: If you purchased your replacement headlight from Go-Parts, it likely has the bulbs already included (as most of our models do), which saves you time! You can now move onto the installation of your new assembly.
Step 5: Connect the wiring harnesses to the back of the new headlight assembly and move it into place.
Step 6: Secure the headlight into place by tightening the three 10mm retaining bolts.
There are two adjusters on the back of the assembly. If you feel that you'd like to calibrate it, simply turn the light on, compare it to the other side, and adjust accordingly.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: