Step 1: Loosen the 8mm bolt to the inside of the headlight assembly.
Step 2: Remove the two retaining clips that hold the assembly in place.
You may need to use a screwdriver to pry these clips free from the casing.
Step 3: Remove the headlight assembly.
Step 4: Disconnect the electrical harness from the old assembly.
NOTE: If you purchased your replacement headlight from Go-Parts, it may have all of the bulbs included. If so, you won't have to worry about disconnecting the sockets from the old assembly!
Step 5: Connect the wiring harness to the new headlight assembly.
Step 6: Position the new headlight assembly and reconnect the retaining clips.
Step 7: Tighten the 8mm bolt to finalize the installation.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: