Step 1: Locate and remove the 7 Phillips screws that hold the interior door panel in place.
Step 2: Gently pull the interior door panel from the frame. Remove it completely.
You will hear the clips disengage as you gently pull on it. Don't break them!
Step 3: Remove the electrical harnesses from the interior door panel.
Step 4: Using the flathead screwdriver, pry the bolt cover from the interior trip panel (near the mirror).
Step 5: Remove the two 6 mm bolts that hold the panel in place.
Step 6: Disconnect the wiring harness from the mirror.
Step 7: Remove the 11mm bolts that secure the side mirror to the door.
Step 8: Remove the side mirror.
Step 9: Attach the new mirror to your vehicle and tighten the 11mm retaining bolts.
Insert the mirror "top first", then the bottom will feed in properly.
Step 10: Reconnect the electrical harness to the mirror.
Step 11: Reattach the interior trim panel.
Step 12: Reattach the interior door panel.
Be sure to reconnect all of the wiring harnesses properly before you reattach the panel!
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: