Step 2: Using the Phillips screwdriver, turn and release the small clip that is just above the headlight assembly.
Step 3: Pulling with some force, remove the turn signal light from the vehicle. Disconnect the wiring harness.
Step 4: Loosen and remove the four 10mm retaining bolts that hold the headlight assembly in place.
Two of these bolts are located on the inner portion of the mount (by the radiator), one is one top of the assembly, and the final bolt was exposed by removing the turn signal assembly.
Step 5: Disconnect the headlight's wiring harness, and pull it from the vehicle.
NOTE: If you ordered your replacement headlight from Go-Parts, it likely includes new bulbs, as most of our models do. This saves you an installation step! However, if your particular model does not, simply transfer the bulbs and sockets to the new assembly. This process takes just a few moments!
Step 6: Connect the wiring harness to the new headlight, and move it into position.
Use the guiding tabs to ensure properly placement.
Step 7: Secure the headlight assembly by tightening the four 10mm mounting bolts.
Step 8: Reconnect the turn signal's wiring harness, and secure it by re-engaging the Phillips retaining clip.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
04 2004, 03 2003, 02 2002, 01 2001 Toyota Sequoia Headlight Replacement Instructions