Quick Parts Search
Quick Parts Search
Need Some Help?


Go-parts Reviews - SiteJabber


How do you Change, Replace, or Install Broken 2001-2004 Toyota Sequoia Rear Door Panel (Interior) Replacement

Fits Years: 2001, 2002, 2003, 2004


Tools required:

  • Phillips screwdriver

  • Flathead screwdriver (medium and small)

  • Door Panel Clip Tool (or putty knife)


Step 1: Open the vehicle's REAR door.

Step 2: Pry and remove the courtesy light. Disconnect the wiring harness (1).

Step 3: Pry and lift the power window switch panel. Disconnect the wiring harness (1).

Step 4: Pry and remove the screw cover (1) just below the arm rest. Loosen and remove the Phillips screw (1).

Step 5: Pry and remove the screw cover (1) inside the interior door handle. Loosen and remove the Phillips screw (1). Pry and remove the handle's bezel.

Step 6: Disengage the retaining pins (2) near the LATCH side of the interior door panel.


To disengage these pins, simply depress the center of the pin and pull it from its position.

Step 7: Using the door panel clip tool (or putty knife), pry and separate the interior door panel from the door frame.

A series of retaining clips secures the panel to the door frame. By working your way around the outer edge of the panel, you will feel each clip. When you do, pry outward, "popping" them free.

Step 8: You can now LIFT and remove the interior door panel.

NOTE: If any clips stayed with the door panel during removal, use a pair of pliers to pull them from the door and reattach them to the door panel.

Step 9: To reattach the interior door panel, slide it OVER the lip and onto the door frame. Using a FIRM, but not too firm, strike near each retaining clip, "pop" them back into place.

Step 10: Reattach the interior door handle's bezel. Tighten the Phillips screw (1).

Step 11: Tighten the Phillips screw (1) just below the armrest. Reattach the screw cover (1).

Step 12: Connect the wiring harness to the UNDERSIDE of the power window switch panel. Snap the panel back into place.

Step 13: Connect the wiring harness to the back of the courtesy light. Snap the assembly back into place.

Step 14: Re-engage the retaining pins (2) near the door LATCH.



These Part Change / Installation Instructions Apply to
04 2004, 03 2003, 02 2002, 01 2001 Toyota Sequoia Rear Door Panel (Interior) Replacement Instructions
- POPULAR GUIDES: TOYOTA SEQUOIA -

2001-2007 Toyota Sequoia AC Heater Blower Motor Replacement

2001-2007 Toyota Sequoia Fog Light Replacement

2001-2004 Toyota Sequoia Corner Light Replacement

2001-2004 Toyota Sequoia Door Handle (Exterior) Replacement

2001-2004 Toyota Sequoia Door Handle (Interior) Replacement

2001-2004 Toyota Sequoia Door Panel (Interior) Replacement

2001-2004 Toyota Sequoia Engine Air Filter Replacement

2001-2004 Toyota Sequoia Headlight Replacement

2001-2004 Toyota Sequoia Tail Light Replacement


Your cart is completely and totally empty!

USERNAME (Your E-Mail)

PASSWORD
Sign UpForgot Password

Enter email address here:
  


Payment Methods Accepted