Step 1: Pry and remove the bumper's turn signal assembly.
You'll pull the assembly through the FRONT of the bumper.
Step 2: Disconnect the wiring harness attached to the back of the turn signal assembly.
NOTE: Some models do not use wiring plugs on the back of the turn signals. If this is the case for your particular model, simply turn the bulb/socket counter-clockwise, and pull it from the back of the assembly.
Step 3: Connect the wiring harness to the new turn signal assembly.
Step 4: Insert the new assembly into place.
You'll feel the turn signal "snap" into place.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: