Tire Iron (can also use 19mm socket/ratchet/breaker bar
Step 1: Lift the vehicle and secure its position.
Step 2: Locate the plastic protection panel's retaining pin and remove it with the flathead screwdriver.
Step 3: Remove the three 7mm screws that hold the panel in place.
Step 4: Remove the 10mm retaining bolt that holds the lower horn in place.
Step 5: Loosen and remove the 10mm retaining bolts that hold the light in place.
Step 6: You can now remove the fog light assembly.
Step 7: Disconnect the wiring harness from the back of the fog light.
Step 8: Connect the wiring harness to the back of the new fog light assembly.
Step 9: Secure it into place by tightening the 10mm retaining bolts on the back of the assembly.
Step 10: Reattach the lower horn by tightening the 10mm retaining bolt.
Step 11: Reattach the protective panels that cover the back of the light mounting area.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: