Step 2: Beneath the glove compartment, locate the blower motor.
Step 3: Disconnect the wiring harness that is mounted near the blower motor.
This is the blower motor resistor harness.
Step 4: Disconnect the blower motor's wiring harness, and disengage the clips that hold the wiring to the console. This frees up some room.
Step 5: Loosen and remove the three 8mm retaining bolts that hold the blower motor in place.
Step 6: You can now remove the blower motor from the vehicle. Be sure to place the gasket on the new blower motor!
Step 7: Insert the blower motor into position, and secure it by tightening the three 8mm retaining bolts.
Step 8: Connect the resistor and component wiring harnesses.
Step 9: Re-engage the clips that hold the wiring to the console.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
07 2007, 06 2006, 05 2005, 04 2004, 03 2003, 02 2002, 01 2001 Ford Escape AC Heater Blower Motor Replacement Instructions