NOTE: We'll want the wiper out of our way while doing this installation, so turn the battery and wipers on until they reach the UP position, then turn the battery off.
Step 2: Using the flathead screwdriver, pry and remove the screw covers (4) that line the trim panel just beneath the windshield.
Step 3: Loosen and remove the Phillips screws (4).
Step 4: Loosen and remove the Phillips retaining pins (4) that line the bottom edge of the trim panel.
Step 5: Lift and remove the trim panel that covers the debris catch panel. Slide and remove the debris catch trim panel, as well.
Step 6: Lift and remove the cabin air filter from the compartment.
NOTE: We recommend cleaning out the assembly area, as there is likely plenty of dirt, grime, and debris. This means that your air filter has been doing its job!
Step 7: Slide the new cabin air filter into the compartment.
NOTE: The arrows should be pointing DOWN.
Step 8: Reattach the trim panels (2).
Step 9: Re-engage the Phillips retaining clips (4).
Step 10: Tighten the Phillips screws (4) and reattach the screw covers (4).
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
If you're looking for a good deal on the parts mentioned in this instructional guide, be sure to check these out: