Step 1: From underneath the vehicle, remove the three 10mm bolts that hold the plastic panel in place.
This panel covers the fog light mounting area.
Step 2: Disconnect the fog light's wiring harness.
Step 3: Using the flathead screwdriver, gently pry the sides of the fog light assembly outward until you hear the clips disengage.
Step 4: Using the pliers, depress the locking tab, and push the assembly through the FRONT of the vehicle.
NOTE: Adjust your fog light's beam by lengthening or shortening the adjustment stud to match that of the old assembly.
Step 5: Insert the new fog light assembly through the front of the vehicle. By pushing the fog light into position, you should feel the locking tabs engage, securing the assembly.
Step 6: Connect the fog light's wiring harness.
Step 7: Reattach the protective panel by tightening the 10mm bolts that hold it in place.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
07 2007, 06 2006, 05 2005, 04 2004, 03 2003, 02 2002, 01 2001 Toyota Sequoia Fog Light Replacement Instructions