Step 1: Using the 10mm socket, remove the 3 retaining bolts that hold the headlight casing in place.
Step 2: Remove the clip located at the center of the vehicle's bumper cover.
Step 3: Remove the clips located in the wheel wells.
Step 4: Remove the 10mm bolts located in the wheel wells to allow for separation of the bumper cover and the headlight casing.
Step 5: Locate the 10mm bolt that is just below the headlight casing (behind the bumper cover) and remove it.
Step 6: Using the screwdriver, pop the headlight casing from the vehicle.
Step 7: Disconnect the electrical harnesses that powers the headlight.
NOTE: If you purchased your replacement headlight from Go-Parts, your replacement light will be complete with new bulbs. This will help you save steps regarding bulb replacement.
Step 8: Line-up the small clip on the interior of the headlight casing of the vehicle, and use it to line up the headlight upon installation.
Step 9: Reconnect all of the electrical harnesses.
Step 10: Pull the bumper cover out from the vehicle a bit to allow for final positioning of the replacement light.
Step 11: Reattach the bolts and clips that hold the bumper cover in place.
Step 12: Finalize the installation by tightening all of the 10mm bolts that hold the headlight in place.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
04 2004, 03 2003, 02 2002 Toyota Camry Headlight Instructions