Step 1: Locate the two 10mm bolts that are below the headlight assembly (when facing the vehicle), and remove them.
Step 2: In the wheel well, open the small door in the paneling to gain access to the area behind the headlight assembly.
You may need to turn the steering wheel to create a bit more room in the wheel well. This gives you extra space to work.
Step 3: Remove the 10mm bolt that holds the assembly to the vehicle's frame.
Step 4: You can now pull the headlight from the vehicle's chassis.
Step 5: Disconnect the wiring harnesses from the back of the headlight assembly.
NOTE: If you purchased your new headlight assembly from Go-Parts, it likely has new bulbs included in the unit (as most of our models do). This allows you to save steps involving bulb removal and move straight to installation!
Step 6: Connect the wiring harnesses to the back of the new headlight assembly, and move it into position.
Step 7: Secure the new headlight assembly by tightening the 10mm retaining bolt located on the back of the mounting area (in the wheel well) and the two 10mm bolts accessible from the front of the vehicle.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
06 2006, 05 2005, 04 2004 Dodge Durango Headlight Replacement Instructions