Step 1: Using the small flathead screwdriver, gently pry the electronic control panel away from the interior door panel.
Step 2: Disconnect the wiring harnesses attached to it and remove it completely.
Step 3: Using the flathead screwdriver and then your Phillips screwdriver, remove the panel that is behind your interior door handle.
Step 4: With the Phillips screwdriver, remove the two screws at the bottom of the interior door panel.
Step 5: Disconnect the blue clip on the back of the interior door panel and remove the panel entirely.
Step 6: Disconnect the wiring harness attached to the mirror.
Step 7: Remove the three 10mm nuts that hold the mirror in place.
Step 8: Remove the old mirror from the vehicle.
Step 9: Install the new mirror and tighten the bolts to secure its position.
Step 10: Reconnect the electrical harness to ensure proper mirror function.
Step 11: Reattach your interior door panel.
Be sure that you reconnect all of the electrical harnesses, as you don't want to take the panel off again for quite some time!
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
These Part Change / Installation Instructions Apply to
09 2009, 08 2008, 07 2007, 06 2006, 05 2005, 04 2004 Dodge Durango Side Mirror Replacement Instructions