Step 2: Using the flathead screwdriver, pry and remove the retaining clips (8) that secure the radiator cover to the vehicle. You can now lift and remove this shroud cover.
Step 3: Loosen and remove the 10mm bolts (4) that line the TOP of the radiator grille.
Step 4: Squeeze and disengage the metal clips (6) on the BACK of the radiator grille. You can now remove the grille from the vehicle.
Step 5: Loosen and remove the 10mm bolts (2) located on TOP of the headlight assembly.
Step 6: Loosen and remove the 10mm bolt (1) that secures the wheel well liner to the fender. Pull this liner back and remove the LOWER 10mm bolt (1).
Step 7: You can now remove the headlight assembly from the vehicle. Disconnect the wiring harness (1) from the back of the assembly.
NOTE: If you ordered your replacement headlight assembly from Go-Parts, it likely includes NEW bulbs and sockets, as most of our models do. This saves you an installation step! However, if your particular model does not, simply twist and remove the bulbs/sockets from the old assembly and attach them to the new one.
Step 8: Connect the wiring harness (1) to the new headlight assembly, and mount it by tightening the 10mm bolts (3).
Step 9: Tighten the 10mm bolt (1) to secure the wheel well liner to the vehicle.
Step 10: Reattach the grille by "snapping"┬Ł the clips (6) into place and tightening the 10mm bolts (4).
Step 11: Reattach the radiator shroud by re-engaging the retaining clips (8).
These Part Change / Installation Instructions Apply to
13 2013, 12 2012, 11 2011, 10 2010, 09 2009, 08 2008, 07 2007 Chevrolet Silverado Headlight Replacement Instructions