Start Here

How do you Change, Replace, or Install Broken 1998-2000 Dodge Dakota Power Window Switch Replacement

Fits years: 1998, 1999, 2000

All Dodge Dakota for sale Tools required:

  • Phillips screwdriver


Step 1: Open the vehicle's door.

Step 2: Loosen and remove the Phillips screws (5) that hold the interior door panel to the frame.


These screws are located as follows: (2) on the bottom edge, (1) near the side mirror, (1) near the door pull, and (1) inside the interior door handle.

Step 3: You can now lift and remove the interior door panel.

Step 4: Disconnect the wiring harnesses (2) from the back of the interior door panel.

Step 5: Disengage the door handle's locking rod.

Step 6: Loosen and remove the Phillips screws (3) that hold the power window control panel to the interior door panel.

Step 7: You can now remove the power window switch.

Step 8: Mount the new power window switch by tightening the Phillips screws (3).

Step 9: Reconnect the wiring harnesses and re-engage the locking rod.


NOTE: It's a good idea to TEST the power window switch once connected, just to be sure everything is hooked up properly before reattaching the interior door panel.

Step 10: Reattach the interior door panel by tightening the Phillips screws (5).
These Part Change / Installation Instructions Apply to:

98 1998, 99 1999, 00 2000 Dodge Dakota Replacement Instructions

Average Rating: 4.9 of 5 stars
19 Review(s)

Let your friends know this guide can help them!



© 2015 GO-PARTS. All Rights Reserved.