2005 - 2009 Kia Spectra5 Fuel Injection Throttle Body 4 Cyl 2.0L (Cardone 6E-1025)

2005 - 2009 Kia Spectra5
without Cruise Control Relearn procedure may need to be performed upon installation of unit. Please refer to the service manual for vehicle specific instructions.
New Fuel Injection Throttle Body

Product Attributes:

• : A Relearn Calibration Procedure Is Necessary After Installation Of Replacement Throttle Body. Are Your New Throttle Bodies The Same Design As O.e.? Can I Purchase A Throttle Body With A Bigger Bore To Increase Horsepower And Improve My Throttle Response? Do All Throttle Bodies Have An Ice-breaker Mode For Extreme Cold Starts? Do You Sell Throttle Body Spacers? Is It Ok To Bypass The Coolant Hoses? Is There Anything That Has To Be Done After Installing The Replacement Throttle Body? No, Bypassing The Coolant Hoses Is Not Recommended. There Are Cases Where We Sell Units Without Coolant Pipes, Because We Are Following O.e. Supersessions Where The Pipes Have Been Removed. Instructions Are Provided For Rerouting Coolant Hoses. Not All Throttle Bodies Have This Feature, Where The Throttle Valve Is Reversed From Its Normal Movement By The Control Module, Which Breaks Up Any Ice Formation Between The Throttle Bore And Valve. This Feature Is Based On Application. Swapping Your Throttle Body For One With A Bigger Bore Is Not Recommended. The Throttle Bodies We Sell Are Specific To The Application. The Electronic Throttle Body Is A Powertrain Component That Has A Plate, Motor, And Integrated Position Sensors Which Are Utilized To Regulate The Amount Of Air Entering The Engine By Opening The Throttle Valve To A Desired Angle Via Commands From The Veh The Most Common Failure In An Electronic Throttle Body Is The Integrated Throttle Position Sensor. The Etb Is Equipped With High And Low Voltage Reference Throttle Position Sensor For Redundancy. Either One Of These Sensors Could Fail, Or Possibly Both. The New Electronic Throttle Body Is Engineered And Manufactured To Match The O.e. Design. The O.e. Throttle Body Has Coolant Hoses Attached. What’s The Purpose? The Purpose Of The Attached Coolant Hoses Is To Keep The Throttle Body Warm By The Transfer Of Heat From The Coolant To The Housing, Preventing Moisture From Freezing Between The Throttle Body Bore And Throttle Valve During Extreme Cold Temperatures. The Throttle Body Is Also Part Of The Cruise Control, Traction Control, Stability Control, And Pre-crash Systems, As Well As Other Systems That Require Engine Torque Management. We Do Not Sell Throttle Body Spacers, Nor Do We Recommend The Use Of A Spacer. What Causes The Electronic Throttle Body To Fail? What Else Does The Throttle Body Control Other Than Idle Air Bypass And Acceleration Throughout Driving Range? What Happens When An Electronic Throttle Body Fails? What’s An Electronic Throttle Body? When An Electronic Throttle Body Fails, The Controlling Module Will Illuminate The Mil/ses/cel. The Module Will Then Activate A Fail-safe Mode Operation And Gradually Reduce The Engine’s Speed Back To An Idle Rpm. When Installing The New Electronic Throttle Body, There Is No Need To Modify The Vehicle For Installation. Will I Have To Modify Anything On The Vehicle To Install Your New Throttle Body?

All CARDONE 100% New Electronic Throttle Bodies are guaranteed to fit and function like the original due to our proprietary engineering standards. Each unit is built and tested as a complete assembly to ensure quick installation and reliable performance. All components match O.E., ensuring accurate air flow in all driving conditions and peak engine performance.
Suggested purchase quantity: 1

• Most jobs typically require 1 of this item.

Brand: Cardone
Condition: New