1979-1986 Chevrolet K20 Disc Brake Caliper - Front Right (BBB Industries)

Partslink #: 97-17240A

JB7 / JD7 System

$37.13 View part →

✓ In Stock

1979-1986 Chevrolet K20 Disc Brake Caliper - Front Left (Centric)

Partslink #: 141.66014

13" Rear Drum JB7

$31.06 View part →

✓ In Stock

1979-1986 Chevrolet K20 Disc Brake Caliper - Front Right (BBB Industries)

Partslink #: 97-17238A

JB6 / JD6 System

$37.72 View part →

✓ In Stock

1979-1986 Chevrolet K20 Disc Brake Caliper - Front Left (BBB Industries)

Partslink #: 97-17240B

JB7 / JD7 System

$37.13 View part →

✓ In Stock

1979-1986 Chevrolet K20 Disc Brake Caliper - Front Right (BBB Industries)

Partslink #: 97P17240A

JB7 / JD7 System

$39.98 View part →

✓ In Stock

1979-1986 Chevrolet K20 Disc Brake Caliper - Front Left (BBB Industries)

Partslink #: 97-17238B

JB6 / JD6 System

$37.72 View part →

✓ In Stock

1975-1978 Chevrolet K20 Disc Brake Caliper - Front Right (BBB Industries)

Partslink #: 97-17219A

$40.42 View part →

✓ In Stock

1979-1986 Chevrolet K20 Disc Brake Caliper - Front Left (BBB Industries)

Partslink #: 97P17240B

JB7 / JD7 System

$39.98 View part →

✓ In Stock

1979-1986 Chevrolet K20 Disc Brake Caliper - Front Right (BBB Industries)

Partslink #: 97P17238A

JB6 / JD6 System

$40.56 View part →

✓ In Stock

JB6 / JD6 System

$40.56 View part →

Abutment Clips Included: No, Anti-Rattle Spring Included: Yes, Bleeder Screw Cap Included: No, Bleeder Screw Included: Yes, Bleeder Screw Quantity: 1, Bleeder Thread Size: M10x1.5, Bracket Included: No, Caliper Color: Gray, Caliper Finish: Oil Emulsion, Caliper Slides Included: Yes, Caliper Type: Floating, Casting Number: 18007149, Contains Electronic Components: No, Disc Brake Caliper Casting Material: Cast Iron, Does it require SDS: No, Dust Boots Included: Yes, FAA_A1: Not Recommended. The O.e. Manufacturers Specified Steel Or Phenolic Pistons Based On The Intended Use Of The Vehicle. It Is Recommended That The Installer Follow The Manufacturer’s Recommendations., FAA_A2: As A Rule, Always Use Brake Fluid Recommended By O.e. The Fluid Type Is Stamped On The Master Cylinder Reservoir Lid. Always Use New Fluid In A Sealed Container., FAA_A3: Inspect Both Calipers For Binding Or Sticky Slides Or Pins. Also Ensure That Brake Hoses Are Not Collapsed Or Restricted And Inspect Steering/suspension Components For Proper Operation., FAA_A4: Brake Squeal Can Be Caused By Improper Installation Of The Brake Pads, Improperly Installed Brake Hardware And Improper Brake Rotor Finish., FAA_A5: A Symptom Of A Low Brake Pedal Is Usually Caused By Air In The System, Misadjusted Rear Brake Shoes, Deteriorated Brake Hose(s) Or A Defective Master Cylinder., FAA_A6: A Silicone Grease Is Used On Floating Caliper Mounting Pins., FAA_A7: New Hardware Is Included With All Of Our Calipers However The Mounting Bracket Is An Added Option Depending On Part Number And Application. Mounting Brackets Are Also Sold Separately For Most Applications., FAQ_Q1: Can I Switch Out A Phenolic Piston Caliper For A Steel Piston Caliper Or Vice Versa?, FAQ_Q2: What Type Of Fluid Should I Use: Dot 3, Dot 4, Or Dot 5?, FAQ_Q3: Car Pulls To One Side During Braking. Why?, FAQ_Q4: Brakes Squeal All Of The Time. What's Causing The Squeal?, FAQ_Q5: Could Calipers Be The Cause Of A Low Brake Pedal?, FAQ_Q6: What Type Of Grease Is Used On Floating Caliper Mounting Pins?, FAQ_Q7: Do All Of Your Calipers Come With The New Hardware And A Mounting Bracket For Installation?, Grade Type: Regular, Inlet Fitting Type: Banjo, Inlet Port Size: 0.394, Inlet Thread Size: M10x1.5, Is Item A Chemical: No, Is Or Contains A Battery: No, Is Or Contains A Bulb: No, Is Prop Sixty Five Affected: No, Is the item CARB affected: No, Mounting Bolt Included: No, Mounting Hardware Included: Yes, Mounting Hole Diameter: 0.708, Mounting Hole Thread Diameter: 0.708, Pad Wear Sensor Included: No, Pads Included: No, Piston Diameter: 2.935, Piston Material: Steel, Piston Quantity: 1, Product Condition: Remanufactured, Rust Resistant Coating: Yes

✓ In Stock

1979-1980 Chevrolet K20 Disc Brake Caliper - Front Right (Cardone)

Partslink #: 18-4124

Installation Hardware Included with 2-15/16 (in) Piston with Brake Code JB6 with Metal Piston GM Brake Codes are on the "Service Parts Identification" Sticker Sell Out and Reorder 18-4208

$59.07 View part →

✓ In Stock

1975-1978 Chevrolet K20 Disc Brake Caliper - Front Left (BBB Industries)

Partslink #: 97P17219B

$45.06 View part →

✓ In Stock

1975-1978 Chevrolet K20 Disc Brake Caliper - Front Right (Raybestos)

Partslink #: RC4071

$61.61 View part →

Abutment Clips Included: No, Anti-Rattle Spring Included: Yes, Bleeder Screw Cap Included: No, Bleeder Screw Included: Yes, Bleeder Screw Quantity: 1, Bleeder Thread Size: M10x1.5, Bracket Included: No, Caliper Color: Gray, Caliper Finish: Oil Emulsion, Caliper Slides Included: Yes, Caliper Type: Floating, Casting Number: 18007149, Contains Electronic Components: No, Disc Brake Caliper Casting Material: Cast Iron, Does it require SDS: No, Dust Boots Included: Yes, FAA_A1: Not Recommended. The O.e. Manufacturers Specified Steel Or Phenolic Pistons Based On The Intended Use Of The Vehicle. It Is Recommended That The Installer Follow The Manufacturer’s Recommendations., FAA_A2: As A Rule, Always Use Brake Fluid Recommended By O.e. The Fluid Type Is Stamped On The Master Cylinder Reservoir Lid. Always Use New Fluid In A Sealed Container., FAA_A3: Inspect Both Calipers For Binding Or Sticky Slides Or Pins. Also Ensure That Brake Hoses Are Not Collapsed Or Restricted And Inspect Steering/suspension Components For Proper Operation., FAA_A4: Brake Squeal Can Be Caused By Improper Installation Of The Brake Pads, Improperly Installed Brake Hardware And Improper Brake Rotor Finish., FAA_A5: A Symptom Of A Low Brake Pedal Is Usually Caused By Air In The System, Misadjusted Rear Brake Shoes, Deteriorated Brake Hose(s) Or A Defective Master Cylinder., FAA_A6: A Silicone Grease Is Used On Floating Caliper Mounting Pins., FAA_A7: New Hardware Is Included With All Of Our Calipers However The Mounting Bracket Is An Added Option Depending On Part Number And Application. Mounting Brackets Are Also Sold Separately For Most Applications., FAQ_Q1: Can I Switch Out A Phenolic Piston Caliper For A Steel Piston Caliper Or Vice Versa?, FAQ_Q2: What Type Of Fluid Should I Use: Dot 3, Dot 4, Or Dot 5?, FAQ_Q3: Car Pulls To One Side During Braking. Why?, FAQ_Q4: Brakes Squeal All Of The Time. What's Causing The Squeal?, FAQ_Q5: Could Calipers Be The Cause Of A Low Brake Pedal?, FAQ_Q6: What Type Of Grease Is Used On Floating Caliper Mounting Pins?, FAQ_Q7: Do All Of Your Calipers Come With The New Hardware And A Mounting Bracket For Installation?, Grade Type: Regular, Inlet Fitting Type: Banjo, Inlet Port Size: 0.394, Inlet Thread Size: M10x1.5, Is Item A Chemical: No, Is Or Contains A Battery: No, Is Or Contains A Bulb: No, Is Prop Sixty Five Affected: No, Is the item CARB affected: No, Mounting Bolt Included: No, Mounting Hardware Included: Yes, Mounting Hole Diameter: 0.708, Mounting Hole Thread Diameter: 0.708, Pad Wear Sensor Included: No, Pads Included: No, Piston Diameter: 2.935, Piston Material: Steel, Piston Quantity: 1, Product Condition: Remanufactured, Rust Resistant Coating: Yes

✓ In Stock

1979-1980 Chevrolet K20 Disc Brake Caliper - Front Left (Cardone)

Partslink #: 18-4125

Installation Hardware Included with 2-15/16 (in) Piston with Brake Code JB6 with Metal Piston GM Brake Codes are on the "Service Parts Identification" Sticker Sell Out and Reorder 18-4209