Chevrolet Malibu Exhaust Muffler Replacement

with Single Exhaust

Modifications and/or Additional Parts May Be Required for Installation

with 18 (in) Muffler Body Modifications and/or Additional Parts May Be Required for Installation

Modifications and/or Additional Parts May Be Required for Installation

DIRECT FIT MSL/MAXIMUM Muffler OE system was a welded assembly. It is recommended that all parts noted [1] should be replaced. (2004 w/ 2 Piece Converter Design)

with Dual Exhaust

If welded assembly, replace all required parts

with 18 (in) Muffler Body Modifications and/or Additional Parts May Be Required for Installation

If welded assembly, replace all required parts

If welded assembly, replace all required parts

with Dual Exhaust

If welded assembly, replace all required parts

If welded assembly, replace all required parts

If welded assembly, replace all required parts

2.5 in. Offset Inlet/Opposite Side Offset Outlet; Case Dimensions 4 in. x 9.75 in. x 13 in.; 19 in. Overall Length; Aluminized Steel Not Direct Fit-Some Adaptation Required

2 in. Offset Inlet/Center Outlet; Case Dimensions 4 in. x 9.75 in. x 13 in.; 19 in. Overall Length; Aluminized Steel Not Direct Fit-Some Adaptation Required

2 in. Offset Inlet/Center Outlet; Case Dimensions 4 in. x 9.75 in. x 17 in.; 23 in. Overall Length; Aluminized Steel Not Direct Fit-Some Adaptation Required

2.5 in. Offset Inlet/Opposite Side Offset Outlet; Case Dimensions 5 in. x 10 in. x 17 in.; 23 in. Overall Length; Aluminized Steel Not Direct Fit-Some Adaptation Required

2.5 in. Offset Inlet/Opposite Side Offset Outlet; Case Dimensions 5 in. x 10 in. x 22 in.; 28 in. Overall Length; Aluminized Steel Not Direct Fit-Some Adaptation Required

with Dual Exhaust If welded assembly, replace all required parts

with Single Exhaust If welded assembly, replace all required parts