It is the main ECU and was tested in a running vehicle. This module may need to be reprogrammed to work with your vehicle.
Condition: Excellent (A)
Mileage: 47,600 miles
It is the main ECU and was tested to be in good working order. This part may need to be reprogrammed to work with your vehicle.
Condition: Excellent (A)
Mileage: 95,900 miles
It was removed from a vehicle that ran well.
Condition: Excellent (A)
Mileage: 121,700 miles
It is not for plug-in hybrid models. This module may need to be reprogrammed to work with your vehicle.
Condition: Excellent (A)
Mileage: 34,000 miles
It is an engine control module for vehicles with a 3.5L engine, automatic transmission, and front-wheel drive. This part is for 4-door models. The control module may require programming to work with your vehicle.
Condition: Excellent (A)
Mileage: 138,700 miles
Condition: Excellent (A)
Mileage: 159,000 miles
The vehicle ran well with this part installed. This control module must be reprogrammed to your vehicle's calibration strategy. It is designed for vehicles with the 2.0L turbo or 2.3L engine.
Condition: Excellent (A)
Mileage: 43,000 miles
It was removed from a vehicle that ran well. This part is for vehicles with the 3.7L engine and without a turbo. The module must be reprogrammed to work properly with your vehicle.
Condition: Excellent (A)
Mileage: 105,800 miles
This part is an EEC processor.
Condition: Excellent (A)
Mileage: 147,000 miles
It fits vehicles with a 4.0L engine and automatic transmission. It is for rear-wheel drive models with 4 doors. This engine control module may require programming to work with your vehicle.
Condition: Excellent (A)
Mileage: 204,600 miles
Condition: Excellent (A)
Mileage: 65,000 miles
This part is also called a main ECU. This module may need to be reprogrammed to your vehicle to work correctly. This part is for hybrid vehicles.
Condition: Excellent (A)
Mileage: 2,800 miles
It was removed from a vehicle that ran well. This module may need to be reprogrammed to your vehicle to work.
Condition: Excellent (A)
Mileage: 17,900 miles
It was removed from a vehicle that ran well. This part is also called a main ECU or EEC processor. This module must be reprogrammed to work properly with your vehicle.
Condition: Excellent (A)
Mileage: 111,800 miles
It was removed from a vehicle that ran well. This part must be reprogrammed to work with your vehicle.
Condition: Excellent (A)
Mileage: 133,900 miles
This module may need to be reprogrammed to your vehicle to work.
Condition: Excellent (A)
Mileage: 19,000 miles
This is an engine control module (ECM).
Condition: Excellent (A)
Mileage: 283,000 miles
Condition: Excellent (A)
It is an engine control module for vehicles with a 4.0L engine and 4-speed automatic transmission. This part fits rear-wheel drive, 4-door models. The unit is an EEC control processor located at the right kick panel.
Condition: Excellent (A)
Mileage: 198,000 miles
For vehicles with the 5.0L engine, rear-wheel drive, and a 4-speed automatic transmission.
Condition: Excellent (A)
Mileage: 250,500 miles
Condition: Excellent (A)
Mileage: 77,000 miles
It fits vehicles with the 4.0L engine, 5-speed automatic transmission, and rear-wheel drive.
Condition: Excellent (A)
Mileage: 146,900 miles
Condition: Excellent (A)
Mileage: 96,000 miles
This part is an EEC processor. This control module may require programming to work with your vehicle.
Condition: Excellent (A)
Mileage: 88,000 miles
It fits 4-door vehicles with a 3.3L engine and 10-speed automatic transmission. It is for vehicles with all-wheel drive and without the hybrid system. This module may need to be reprogrammed to work with your vehicle.
Condition: Excellent (A)
Mileage: 54,200 miles
It is an engine control module for vehicles with a 4.0L engine, 5-speed automatic transmission, and 4-wheel drive. It fits 2-door models and vehicles equipped for flex fuel. Please verify that your part identification number matches.
Condition: Excellent (A)
Mileage: 226,300 miles
It fits vehicles with rear-wheel drive, a 4.0L engine, and a 5-speed automatic transmission. This control module may require programming to work with your vehicle.
Condition: Excellent (A)
Mileage: 246,600 miles
It was removed from a vehicle that ran well. This part may need to be programmed to work with your vehicle.
Condition: Excellent (A)
Mileage: 72,000 miles
Condition: Excellent (A)
Mileage: 181,000 miles
PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID ML2-8A1,8A1A Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues
PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID ML2-463 Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues
ID #(s) F5TF-ARC This Unit is Pre-Programmed at the Factory
ID #(s) F27F-VA, VB This Unit is Pre-Programmed at the Factory with Federal Emissions System
ID #(s) F17F-ZA This Unit is Pre-Programmed at the Factory
This Unit is Pre-Programmed at the Factory with Calibration # 6-58B Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood
PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID ML2-8B1 Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues
This Unit is Pre-Programmed at the Factory with Calibration # 7-58C Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood
ID #(s) F37F-ZB This Unit is Pre-Programmed at the Factory with Federal Emissions System
This Unit is Pre-Programmed at the Factory with Calibration # 6-54G Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood
It is for vehicles with the 4.6L engine and rear-wheel drive. This part may need to be programmed to work with your vehicle.
Condition: Excellent (A)
Mileage: 189,200 miles
PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID MP2-113 Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues
Condition: Excellent (A)
Mileage: 19,000 miles
Browse our selection of quality engine control module (ecm) parts designed specifically for your Ford Explorer. We carry options across multiple trim levels, body styles, and engine configurations to ensure a perfect fit.
4x4 · Active · Active 100A · Base · Eddie Bauer · Expedition · King Ranch · Limited · Limited Hybrid · NBX · Platinum · Platinum Hybrid · Police Interceptor · Postal · ST · ST-Line · Sport · Timberline · Tremor · XL · XL Fleet · XLS · XLS Sport · XLT · XLT Base · XLT Sport
SUV · Sport Utility · Stripped Chassis
L4 2.0L · L4 2.3L · V6 3.0L · V6 3.3L · V6 3.5L · V6 4.0L · V8 4.6L · V8 5.0L
Automatic · Manual
