Ford F-250 Super Duty Engine Control Module (ECM) Replacement

It is the main ECU (electronic control unit) for the engine. This part was tested and the vehicle ran well. This module must be reprogrammed to work properly with your vehicle.

Condition: Excellent (A)
Mileage: 108,200 miles

Condition: Excellent (A)
Mileage: 84,000 miles

This part is an engine electronic control processor. The control module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 73,900 miles

It fits vehicles with the 6.7L diesel engine.

Condition: Excellent (A)
Mileage: 64,000 miles

Condition: Excellent (A)
Mileage: 162,500 miles

It is also referred to as the main ECU.

Condition: Excellent (A)
Mileage: 117,900 miles

Condition: Excellent (A)
Mileage: 21,000 miles

Condition: Good (B)
Mileage: 122,000 miles

It is for vehicles with the 6.7L diesel engine.

Condition: Excellent (A)
Mileage: 21,000 miles

It is for vehicles with the 6.7L engine.

Condition: Excellent (A)
Mileage: 116,700 miles

This module may need to be reprogrammed to your vehicle to work.

Condition: Good (B)
Mileage: 105,000 miles

Condition: Excellent (A)
Mileage: 130,800 miles

It is for vehicles with a 5.4L engine and 4-speed automatic transmission. It fits 4-door, rear-wheel drive models.

Condition: Excellent (A)
Mileage: 247,600 miles

Please verify your part identification number matches. This module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 124,400 miles

PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID MLC-496, 496A Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues

For vehicles with a 5.4L engine, 4-speed automatic transmission, and 4-wheel drive. Fits 4-door models.

Condition: Excellent (A)
Mileage: 281,700 miles

This part is an engine electronic control processor. This control module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 100,600 miles

This part is also called the main ECU. The module may need to be reprogrammed to your vehicle to work properly.

Condition: Excellent (A)
Mileage: 105,600 miles

This module may need to be reprogrammed to work with your vehicle.

Condition: Excellent (A)
Mileage: 38,000 miles

Condition: Excellent (A)
Mileage: 75,000 miles

This part is an EEC control processor.

Condition: Excellent (A)
Mileage: 123,500 miles

This part may need to be reprogrammed to work with your vehicle.

Condition: Good (B)
Mileage: 73,000 miles

It is the main ECU and was tested to be in good working order. This module must be reprogrammed to your vehicle's calibration strategy.

Condition: Excellent (A)
Mileage: 110,700 miles

The module may need to be reprogrammed to work with your vehicle.

Condition: Good (B)
Mileage: 91,000 miles

It fits vehicles with 4-wheel drive, the 6.7L engine, and a 6-speed automatic transmission. The control module must be reprogrammed to the vehicle's calibration strategy.

Condition: Excellent (A)
Mileage: 84,100 miles

This glow plug control module fits vehicles with the RC3A-12C550-EF unit.

Condition: Excellent (A)

The module may need to be reprogrammed to your vehicle to work properly.

Condition: Excellent (A)
Mileage: 28,000 miles

The module may need to be reprogrammed to work with your vehicle.

Condition: Excellent (A)
Mileage: 40,000 miles

This module may need to be reprogrammed to your vehicle to work.

Condition: Good (B)
Mileage: 79,000 miles

This is a set that includes the engine control module and the glow plug module. This part is dented. The module may need to be reprogrammed to your vehicle to work with your vehicle.

Condition: Good (B)
Mileage: 100,000 miles

Condition: Good (B)
Mileage: 101,000 miles