Ford Mustang Engine Control Module (ECM) Replacement

It is an engine control module for vehicles with a 4.0L engine and 5-speed automatic transmission. It fits 2-door, rear-wheel drive models. This control module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 147,900 miles

It is the main ECU and was tested in a running vehicle. This module may need to be reprogrammed to work with your vehicle.

Condition: Excellent (A)
Mileage: 47,600 miles

It is the main ECU (electronic control unit) for the engine. This part was tested and the vehicle ran well. This module must be reprogrammed to work properly with your vehicle.

Condition: Excellent (A)
Mileage: 108,200 miles

It is for 2-door models. This is an engine control module (ECM).

Condition: Excellent (A)
Mileage: 172,900 miles

It fits vehicles with a 3.7L engine and a 6-speed automatic transmission. It is for rear-wheel drive, 2-door models. This control module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 168,700 miles

The vehicle it was removed from ran well. This module may need to be reprogrammed to work with your vehicle.

Condition: Excellent (A)
Mileage: 67,700 miles

This part is an electronic engine control processor. The control module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 117,000 miles

It was tested and the vehicle ran well before removal. This part is the main engine computer (EEC processor). The module must be reprogrammed to work properly with your vehicle.

Condition: Excellent (A)
Mileage: 69,000 miles

It is for vehicles with an automatic transmission and Federal emissions standards.

Condition: Excellent (A)
Mileage: 60,000 miles

It is an Engine Control Module for vehicles with a 4.0L engine and 5-speed automatic transmission. It fits 2-door, rear-wheel drive models. Please verify the part identification number matches your original unit. This control module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 174,900 miles

It fits vehicles with a 2.3L engine, automatic transmission, and rear-wheel drive. This part is for 2-door models. The buyer should verify the part identification number matches. This module must be reprogrammed to work properly with your vehicle.

Condition: Excellent (A)
Mileage: 43,800 miles

It is an engine control module for vehicles with a 2.3L engine, 10-speed automatic transmission, and rear-wheel drive. This part is for 2-door models. The module may need to be reprogrammed to work with your vehicle.

Condition: Excellent (A)
Mileage: 19,600 miles

It was tested and the vehicle ran well with this part installed. This part must be reprogrammed to work properly with your vehicle.

Condition: Excellent (A)
Mileage: 44,000 miles

It was removed from a vehicle that ran well. This module must be reprogrammed to work properly with your vehicle.

Condition: Excellent (A)
Mileage: 32,700 miles

Condition: Excellent (A)
Mileage: 77,000 miles

It is an EEC processor. This control module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 108,700 miles

The module may require programming to work with your vehicle.

Condition: Excellent (A)
Mileage: 94,000 miles

ID #(s) E8TF-CUA This Unit is Pre-Programmed at the Factory

ID #(s) E7ZF-AB This Unit is Pre-Programmed at the Factory with Federal Emissions System

ID #(s) E53F-ASB, E63F-BA This Unit is Pre-Programmed at the Factory with California Emissions System

PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID MP2-181 Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues

ID #(s) F1ZZ-BA, BB This Unit is Pre-Programmed at the Factory

This Unit is Pre-Programmed at the Factory with Calibration # 6-37M Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood

This Unit is Pre-Programmed at the Factory with Calibration # 4-15E Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood

ID #(s) F1ZZ-AA, AB This Unit is Pre-Programmed at the Factory

This Unit is Pre-Programmed at the Factory with Calibration # 6-20C Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood

PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID MLC-461 Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues

This Unit is Pre-Programmed at the Factory with Calibration # 4-16E Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood

This Unit is Pre-Programmed at the Factory with Calibration # 6-19C Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood

This Unit is Pre-Programmed at the Factory with Calibration # 6-19A Emission Calibration / Tear Tag on Front Door Jams, in Trunk, or Under Hood

PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID MP2-18C Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required

PATS Module Requires Programming after ECM Install. Correct VIN and OE Number required when ordering All Calibrations with Module ID VK2-R3514 Important: Vehicle Specific Flash Programming Required ON or OFF the Vehicle. Accurate VIN and Mileage are Required Important: Vehicle Specific On-Car Programming must be Performed AFTER Installation to Prevent Drivability and Starting Issues

Condition: Excellent (A)
Mileage: 34,000 miles

Please verify your part identification number matches.

Condition: Excellent (A)
Mileage: 29,000 miles

Please verify your part identification number matches.

Condition: Excellent (A)
Mileage: 12,000 miles

It is an Engine Control Module (ECM) for vehicles with 2 doors. This part is also known as an EEC Control Processor.

Condition: Excellent (A)
Mileage: 132,500 miles