GMC K1500 Drive Shaft Replacement

It fits vehicles with an automatic transmission, a floor shift, and an 8-lug wheel. It is compatible with vehicles equipped with a 4L60E transmission and a 3-switch dash control (option code NP1). It is for vehicles without a 4-switch dash control.

Condition: Excellent (A)
Mileage: 144,400 miles

ID No. DAT wo/RPO Code NP8 (2 Speed, Push Button Shift, Transfer Case)

10 Bolt Differential Cover 8.5 In. Ring Gear

with 29.53 (in) Long Driveshaft Measurement taken from End of the Flange to the Center of U-Joint on the Opposite Side

with 31.73 (in) Long Driveshaft Measurement taken from the centerline of the furthest U-Joint at one end to the centerline of the furthest U-Joint on the opposite end of the collapsed Prop Shaft Supplied as New

with 31.89 (in) Long Driveshaft Measurement taken from the centerline of the furthest U-Joint at one end to the centerline of the furthest U-Joint on the opposite end of the collapsed Prop Shaft

ID No. DAU wo/RPO Code NP8 (2 Speed, Push Button Shift, Transfer Case)

2 Piece Shaft Assembly w/RPO Code F44 (Heavy Duty Chassis)

ID Code CMJ

w/RPO Code F44 (Heavy Duty Chassis)

10 Bolt Differential Cover 8.5 In. Rear Axle

12 Bolt Differential Cover 8.87 In. Rear Axle

wo/Heavy Duty Chassis

8.87 In. Rear Axle

1 Piece Shaft Assembly w/NP203 Full Time Transfer Case

1 Piece Shaft Assembly w/NP205 Part Time Transfer Case

2 Piece Shaft Assembly wo/RPO Code F44 (Heavy Duty Chassis)

w/Heavy Duty Chassis